Ideas

The TriggeredOn() function would return true if the inserted attribute was the reason for the expression analysis to trigger/evaluate. I have multiple attributes in the same analysis but only want each line to have an output when its corresponding...

Substitution variables are only supported in datareferences. I want to use these directly in Analytics expressions. Now i need to create a attribute to resolve the substitution variable (formula, stringbuilder, etc.), and use that in my analysis....

If an analysis with multiple trigger attributes is triggerred, it is difficult to assess which attribute produced the trigger. Hasvaluechanged has it's limitations, and comparing PrevEvent is also cumbersome. Instead of only receiving a timestamp...

New functions are needed for most problems in our fileds process and quality: * countif (count with conditions over specified horizon) * for loop (even it might be hard to implementate)

As a PI server Administrator I would like to have a way to decide the PI DA collective member Analysis server should connect. This will allow us to manage better the load on PI DA

Currently, BadVal() in Asset Analytics can handle situations like BadVal(1/0) without throwing a divide by zero error, but the badval() function in the Formula DR cannot. The request is to make them equivalent so that behavior is consistent across...

If I want to create an analysis that generates an event frame in PI System Explorer, often times it's useful to check the values of variables to make sure that a calculation is being done as expected to mitigate error on my end, and make sure I am...

The analysis tab in PSE can take quite some time to load if there are thousands of elements being referenced in the input attributes. This is rare for Expression, Event Frame and SQC analyses, but not as rare for Rollups. Ideally the tab should lo...

Please add PI FrequencyGT and PI FrequencyLT functions in AF analysis, like PI TimeGT and PI TimeLT, which find the frequency (number of times) within a range when an attribute value is greater or less than a given value.

I would like the ability to flag an SQC event only if I am in a batch, on a grade run, or in some other process condition. Right now, I am getting an SQC outside control limit when my phase is "inactive." Let there be more configuration of this in...