Ideas

I would like the ability to flag an SQC event only if I am in a batch, on a grade run, or in some other process condition. Right now, I am getting an SQC outside control limit when my phase is "inactive." Let there be more configuration of this in...

If an existing digital state is edited, PI Analysis Service does not recognize the change until it is restarted. A digital state should not be edited too often. However, it would be useful if there is a process to update cache, including each digi...

As PI server administrator I would like that when the Analysis service is restarted with autobackfilling enabled, if there are any EF analysis where last evaluation time is older than *-MaximumAllowedAutoBackfillingSpanInHours, EFs that are opened...

The PI data archive (and potentially other systems) can generate many automated error messages to assist with troubleshooting. One such key example is "[-10767] Client exceeded maximum concurrent queries in RPC thread pool", which occurs when a se...

When you develop an expression it is very useful to use the preview function. Quite often you can discover and debug directly from this, but you are not abel to close down the window and check the code! So either you memorise or you export the cs...

The description for the MarkArchiveGaps tuning parameter for a value of 2 is unclear. A user might interpret: 2 - Gap markers only when there is an actual gap between two consecutive archives. to mean that markers are shown when a tag does not h...

Provide a way to have an online, dynamic inventory of installed PI System components, especially interfaces.

PI System Management Tools is more of a client-side program, so it does not make sense for it to be packaged with a server-side program like the PI Interface Configuration Utility. This increases the size of the install kit, increases the extracti...

In Asset Analytics, there isn't a way to include a filtering function in a single analytic. For example, you may be calculating run hours on a motor, but there is no way to filter the calculation so that it is only done when the motor is running.

It would be useful Dismiss all completed recalculations in Analysis Management tab > Pending operations when requesting multiple recalculations at the same time.