Ideas

Please add PI FrequencyGT and PI FrequencyLT functions in AF analysis, like PI TimeGT and PI TimeLT, which find the frequency (number of times) within a range when an attribute value is greater or less than a given value.

When using the preview analysis function an an analysis with many variables the preview graph and table struggles to keep up, and uses a long time to update. When there are many variables, these are also quite useless. It would therefore be an i...

I would like the ability to flag an SQC event only if I am in a batch, on a grade run, or in some other process condition. Right now, I am getting an SQC outside control limit when my phase is "inactive." Let there be more configuration of this in...

If an existing digital state is edited, PI Analysis Service does not recognize the change until it is restarted. A digital state should not be edited too often. However, it would be useful if there is a process to update cache, including each digi...

As PI server administrator I would like that when the Analysis service is restarted with autobackfilling enabled, if there are any EF analysis where last evaluation time is older than *-MaximumAllowedAutoBackfillingSpanInHours, EFs that are opened...

The PI data archive (and potentially other systems) can generate many automated error messages to assist with troubleshooting. One such key example is "[-10767] Client exceeded maximum concurrent queries in RPC thread pool", which occurs when a se...

When you develop an expression it is very useful to use the preview function. Quite often you can discover and debug directly from this, but you are not abel to close down the window and check the code! So either you memorise or you export the cs...

It would be useful to add a Check In and Check Out button to PI Builder. So if any undesired change is made, it can be undone.

In Asset Analytics, there isn't a way to include a filtering function in a single analytic. For example, you may be calculating run hours on a motor, but there is no way to filter the calculation so that it is only done when the motor is running.

It would be useful Dismiss all completed recalculations in Analysis Management tab > Pending operations when requesting multiple recalculations at the same time.