Ideas

Posted on behalf of a customer. As of PI Server 2018 SP3, simulator interfaces have been removed from the PI Server setup kit, and the default PI Points are no longer installed. These were very important to check if the server installation went w...

Data Read and Date Write (Buffering) from/to PI Data Archive is based on the priority settings in PI SDK and PSE. We have a architecture of 6 member PI collective and all the source data is not buffered to the individual collective. Hence for othe...

As a PI Administrator in a regulated environment, it would be helpful if the Archive audit trail data exported by the pidiag -xa command included the username associated with each action. Currently, the pidiag -xa exports of archive audit logs do ...

Substitution variables are only supported in datareferences. I want to use these directly in Analytics expressions. Now i need to create a attribute to resolve the substitution variable (formula, stringbuilder, etc.), and use that in my analysis....

If an analysis with multiple trigger attributes is triggerred, it is difficult to assess which attribute produced the trigger. Hasvaluechanged has it's limitations, and comparing PrevEvent is also cumbersome. Instead of only receiving a timestamp...

New functions are needed for most problems in our fileds process and quality: * countif (count with conditions over specified horizon) * for loop (even it might be hard to implementate)

As a PI server Administrator I would like to have a way to decide the PI DA collective member Analysis server should connect. This will allow us to manage better the load on PI DA

Currently, BadVal() in Asset Analytics can handle situations like BadVal(1/0) without throwing a divide by zero error, but the badval() function in the Formula DR cannot. The request is to make them equivalent so that behavior is consistent across...

If I want to create an analysis that generates an event frame in PI System Explorer, often times it's useful to check the values of variables to make sure that a calculation is being done as expected to mitigate error on my end, and make sure I am...

The analysis tab in PSE can take quite some time to load if there are thousands of elements being referenced in the input attributes. This is rare for Expression, Event Frame and SQC analyses, but not as rare for Rollups. Ideally the tab should lo...